Can NanoStation be used as access point?
I confirmed this on the UBNT forums. 2 of 3 found this helpful. Do you? It can be used as an access point, but has to be set to 20Mhz channel width and Airmax disabled to communicate with standard wifi devices.
How do I setup my rocket M2 as an access point?
Ubiquity rocket m2 as a wifi access point
- Network Role. Network Mode:bridge. Disable Network: none.
- Configuration Mode. Configuration Mode: simple.
- Management Network Settings. Management IP Address: Static. IP Address: 192.168.0.240. Netmask: 255.255.255.0. Gateway IP:192.168.0.1. Primary DNS IP:192.168.0.1. Secondary DNS IP:
What is Ubiquiti Rocket M2?
The Rocket M2 is a rugged, hi-power, very linear 2×2 MIMO radio with enhanced receiver performance. It features incredible range performance (50+km) and breakthrough speed (150+Mbps real TCPI/IP).
How do you reset a rocket M2?
Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the Rocket is already powered on. Power The Power LED will light green when the device is connected to a power source.
How do I set Ubiquiti device to point-to-point?
User Tips
- Select the correct cable. Use Ubiquiti ToughCable Pro shielded twisted pair data cable between your Power over Ethernet adapter and your radio.
- Secure the radios. Modify the default administration account name and password now.
- Secure the wireless signal. Encrypt the wireless connection.
What is the Beginner’s setup guide for nanostation-m2?
Page 1 Beginner’s SETUP GUIDE for NANOSTATION-M2 as receiver and other Ubiquity airMAX devices using AirOS firmware v5 (Windows/MacOS) This guide is primarily intended for mobile users (boaters, campers and truckers) who often change access points.
How do I Find my Nanostation’s IP address?
There should then be at least one LED lit on the back of the Nanostation. On the original Nanostation shipping box, find and write down the default IP address (we assume:192.168.1.20), the user name and password (should both be “ubnt”). Do not loose this information!
How do I connect nano to my computer?
1) Set your computer to communicate with Nano (only done once) 1a) Windows 1b) Mac OS X 2) Program Nano as receiver (station) and router (only done once) 3) Choose and connect to a WIFI signal (done to find a new access point) Windows XP • Open Start/ Control panel/ Network Connections.
