How do you drag an infield nail?
Use the following components to build your nail drag:
- Build with 2″x4″ boards.
- Pre-drill straight holes for nails.
- Use 40 penny nails.
- Use 1″x4″ to cover 2″x4″ on top to hold in nails.
- Use eye bolts and a chain for fulling.
- Stagger nails 1″ apart and have 2 rows in each board.
When should you nail drag a baseball field?
Following a rain event – It’s highly beneficial to get a nail drag onto your infield skin as soon as you can. Remember that regardless of the exact ratio of sand, silt and clay in your infield mix, heavy rain will cause most of the finer sized particles to sink and the coarser sand to rise to the top.
Why do you nail drag a baseball field?
A nail drag is a very valuable tool for maintain your infield, but it must be used with great caution. The main reason for nail dragging is to cut down small undulations, permitting the looser material to be smoothed out by a subsequent pass with a screen drag. The drag should never penetrate more than ¼-½” deep.
Why do they drag the infield?
The purpose of these types of drags is to loosen the top ¼” to ½” layer of material at the surface of the infield. Remember, a metal baseball cleat is only 3/8” long so you really don’t want to penetrate much deeper.
Can you drag a wet baseball field?
It may seem contrary as rain is on it’s way, but keep moisture in your infield so that it maintains a firm stable surface. Drag your infield with a rigid steel drag mat to help seal off the surface. Again, always important to make sure there is some moisture in the infield surface otherwise it will not seal off.
How do you groom a baseball infield?
GROOMING
- Remove all bases and fill each hole with a rubber plug or similar product.
- Use a nail drag to “scarify” the field, which helps break up hard and compacted material on the infield.
- After scarifying the field, finish grooming the field with a drag mat or broom.
How do you drag an infield skin?
Start your drag on the edge of the infield skin and work your way inward, ending somewhere around the middle of the infield. The drag loads up with material on the outside and leaves it in the center when you’re done. This helps maintain proper surface grade and drainage.
Can you drag a wet field?
Drag your infield with a rigid steel drag mat to help seal off the surface. Again, always important to make sure there is some moisture in the infield surface otherwise it will not seal off. Do not nail drag or open up your infield prior to a rain event.
How do you dry an infield?
Rake into the infield mix. This process will keep your field level and will minimize the amount of infield material pulled into your turf. Pour on Turface Quick Dry and let it absorb the water and mud. After 10 minutes, rake the area thoroughly.
Can you use a nail drag for infield dirt?
With proper watering, raking and dragging techniques, you can certainly have an acceptable infield surface. Working with a nail drag is about taking your infield dirt to a higher level. Before jumping into the details of the nail drag and what it can do for you, the questions of time and field expectations come into play.
What can a nail drag do for You?
Working with a nail drag is about taking your infield dirt to a higher level. Before jumping into the details of the nail drag and what it can do for you, the questions of time and field expectations come into play.
How long does a nail drag take?
Before jumping into the details of the nail drag and what it can do for you, the questions of time and field expectations come into play. At the professional level, the game day nail drag process can be very involved and take at least two hours, including finish screen dragging and midday watering.
How do you nail drag a baseball field?
The entire infield surface should be nail dragged in two or three directions, and small areas that need attention can get extra passes. Once you have worked everything to your satisfaction, you can screen drag to finish the surface prior to your mid-day watering.