What is a detent valve on a log splitter?
The detent valve in a log splitter is the central assembly where the unpressurized hydraulic fluid interacts with the pressurized hydraulic fluid, creating the necessary reactions that make the log splitter work in the first place.
What is a detent on a valve?
WHAT IS A DETENT? – A spring device which maintains the spool of a directional control valve in position.
How do you adjust the relief valve on a log splitter?
Relief valve is normally adjusted to about 2,000 PSI (138 bar) at 2 GPM (7.6 lpm) at the factory. Adjustment can be made by removing the relief valve plug and by turning the slotted or hex-keyed adjustment screw clockwise to increase the pressure and counterclockwise to decrease the pressure.
What is a detent solenoid valve?
A solenoid operated directional valve with detent means for retaining the spool of the valve in either of two selected positions, the detent means being operatively associated with the solenoid pins for holding one or the other of the pins in a selected position and thereby for retaining the spool in a selected …
How do I increase the speed of my log splitter?
Only way to speed up a splitter is to move more oil. Either get a bigger pump or speed up the existing pump.
Why does log splitter lose power?
Temperature could also be the culprit for loss of driving force, as hydraulic oil is more viscose in cold weather resulting in a weak response until the machine warms up. If it is not any of the above, then the log splitting machine may require a piston or pump replacement.
What does no detent mean?
“Detent” just means that the spool will lock into a position. A “Float” position is where the 2 work ports are connected together and also connected to tank. The pressure port usually is connected to the “out” or “power beyond ” port when in float position.
How do you adjust a detent hydraulic valve?
Do the following:
- Turn off the engine.
- Relieve fluid pressure in the system by cycling the control lever a few times.
- Put the control lever in the neutral position.
- Loosen the locking nut (closest to the valve) on the return detent adjustment bolt.
- Turn the bolt clockwise 1/4 turn to tighten the relief spring.
How do you increase hydraulic pressure in a log splitter?
Twist the screw on the side of the pump clockwise with a flat blade screwdriver to increase pressure, according to the scale printed or embossed on the side. Turning the screw counterclockwise decreases pump pressure. Raise the guards on the sides and back of the splitter to the upright locked position.
What does the detent Kit do on a log splitter?
The detent kit allows for your handle to stay engaged while retracting your log splitter cylinder to the start position. This allows for faster wood splitting cycles when operating your log splitter. Energy Manufacturing Co., Inc. made design improvements and upgrades to its log splitter valve detent assembly in 2008.
What kind of valve does a log splitter use?
Fits the OEM hydraulic valve used on many popular log splitters from Speeco, Ariens, Brave, Dirty Hand Tools, Huskee, County Line, Yardmax, MTD, Northern Tool, and others. Check valve type on your splitter before ordering.
What is the pre-set kickout pressure for the inlet relief valve?
Pre-set kickout pressure of 750 psig to 2,000 psig (52 bar to 138 bar) NOTE! Maximum flow rate for the inlet relief valve is 10 gpm (38 lpm) IMPORTANT!!! Pressure at “T” (return) port in excess of 200 psig (14 bar) may interfere with proper operation of valve.