What is a link 2500?

What is a link 2500?

The Link/2500, from Ingenico Group, is a pocket-sized PIN pad for EMV mobility. It accepts all payment methods: EMV, chip & PIN, magstripe and NFC/contactless transactions and has a 2.4” color display. The Link device is comparable to Ingenico’s iSMP4 and iCMP devices. It can connect via Ethernet.

How do I connect my Ingenico link 2500 to my computer?

To pair, press 0, 0, 0, then 1 on the Link/2500. Use the F3 button to go to 3 – Bluetooth Parameters. Click the green button to confirm your selection. Use the F3 button to go to 2 – Phone pairing.

How do I get to the menu on Link 2500?

These are the steps involved in connecting a Link/2500 chip reader to a WiFi network.

1. If the Link/2500 should power itself on when plugged into a power however.
2. Wait for the device to initialize.
3. To access the admin menu, quickly press the following buttons on the pin pad: 2, 6, 3, 4.
4. Press F to enter the menu:

How do I turn off Link 2500?

Power On and Off Link/2500. To power on Link/2500, press the Green keypad button. To power off Link/2500, unplug the device then press the .,#* and Yellow keypad buttons simultaneously.

How do you open the lane on a Ingenico Link 2500?

Link 2500 – Resolve Lane Closed Message

1. From the This Lane Closed screen, type 2634.
2. Then select F.
3. Choose TDA > Configuration > Communication > Select Comm Type > USB_CDC.
4. After changing it, press the Red button 2 times.
5. Select Yes for save and reboot.

How do I connect Ingenico to my computer?

Connect hardware

1. Plug the connection cable’s flat end into the payment terminal and secure it with the included screws.
2. Plug the power supply into the connection cable’s round end.
3. Plug the connection cable’s USB end into the back of the computer.
4. Plug the power supply into an electrical outlet.

How do I connect my Ingenico card reader to WiFi?

Please complete the following steps carefully:

1. Power on the device by pressing the small power button on top right side of the device.
2. Wait for the start-up splash screen.
3. Press ‘F’ to enter the menu.
4. Press 0 – Telium Manager.
5. Press 3 – Initialization.
6. Press 2 – Hardware.
7. Press 5 – WiFi.
8. Press 2 – Scan Network.

How do I use Bluetooth Ingenico card reader?

Android Device

1. On the Android device, perform the following: Open Settings. Tap Bluetooth. Swipe the toggle button to switch on Bluetooth.
2. On Ingenico iCMP, confirm that the Welcome screen appears.
3. On the Android device, confirm that Ingenico iCMP appears in the Paired Devices list.

How do I connect my Ingenico card reader?

To pair your Ingenico iCMP card reader to your iPad

1. Ensure that your Ingenico iCMP card reader is adequately charged.
2. On the iPad, open settings and turn on Bluetooth.
3. Turn the Ingenico iCMP card reader on by pressing the power button on the right.
4. When BT Pairing Required message appears, press the F1 button.

How do I reset my Ingenico Link 2500 card reader?

Select 1-Yes and press the Green keypad button. Confirm the card reader has fully rebooted. When the Welcome screen appears, press the following keypad buttons in this order: 0, 0, 0, and 1. Depending on your device version you might need to press this combination instead: 0, 0, 0, and 3.