How do you ballast a mot?
Most people (on the cheap) use another MOT to ballast their other MOT’s. To convert the MOT into a ballast, connect one end of the secondary to the MOT’s core (which is usually already done anyway) Then, connect the other end to the core as well. Voila! You have a ballast.
How many amps does a microwave transformer draw?
A standard 1000-watt microwave draws an estimated 10 amps. Average microwaves range from 600 watts to 1200 watts, employing between 5.4 and 10 amps. The higher the wattage, the more amps the microwave requires. The more amps, the quicker the device will cook your food.
What is the secondary voltage of a microwave transformer?
Note: This is a microwave oven transformer. It has an HT secondary winding, and also a 3.15v secondary winding for the magnetron cathode heater filament.
How many amps is a MOT?
Your average mid level MOT can support around 1000 watts or 2000 volts at 0.5 amps.
What is a MOT transformer?
The microwave oven transformer (MOT) If you have removed a microwave oven transformer (MOT) from an old microwave oven, it is possible to reuse it as a low voltage power source for an electronics project requiring hefty power.
How many volts does a microwave capacitor hold?
The high voltage capacitor in a microwave is rated in microfarads, which is one or less and up to 2100 volts.
What is a capacitor charging graph?
The Capacitor Charging Graph is the a graph that shows how many time constants a voltage must be applied to a capacitor before the capacitor reaches a given percentage of the applied voltage. A capacitor charging graph really shows to what voltage a capacitor will charge to after a given amount of time has elapsed.
How do you charge a capacitor to its rated voltage?
A capacitor will always charge up to its rated charge, if fed current for the needed time. However, a capacitor will only charge up to its rated voltage if fed that voltage directly. A rule of thumb is to charge a capacitor to a voltage below its voltage rating.
How do I charge a capacitor bank with a multimeter?
Connect the capacitor bank you want to charge Set the voltage divider potentiometer to the highest resistance Connect a multimeter to the capacitor bank (1000 volt setting) Start the circuit and wait until it turns off automatically
What is a capacitor start motor?
The capacitor start motor also has a centrifugal switch like the split-phase motor which disconnects the start winding and the capacitor when the motor reaches about 75% of the rated speed. It creates more starting torque, typically 200% to 400% of the rated torque since the capacitor is in series with the start circuit.