How do you clean a Wunder bar gun?
Using clean cloth dipped in sanitizer, clean sheathing, allowing to air dry. Do NOT use bar gun handle to break up or stir ice; it will damage the bar gun. Clean nozzles with sanitizer solution and a dedicated nozzle brush. Place nozzles in sanitizing solution for 3 minutes.
Can you soak a bar gun?
Remove the nozzle by turning counter clockwise then pulling down. If the nozzle is difficult to remove, soak only the nozzle part of the bargun in carbonated water for 5 minutes. Rinse the nozzle, then soak it in sanitizing solution for 60-90 seconds, then remove it and allow to air dry.
What do you soak a soda gun in?
Place the bar gun and nozzle in bucket of carbonated water and let soak for 2 minutes. 8. Remove the bar gun and nozzle from the bucket.
How do you clean a drink dispenser nozzle?
- Wash hands.
- Remove nozzles and diffusers from the dispensing valves and clean them with a special nozzle brush and chlorine-based sanitizer solution; soak nozzles and diffusers in the sanitizer solution for about 3 minutes; replace after they dry.
How often should soda lines be cleaned?
In order to keep your soda product tasting best, soda lines should be cleaned on a quarterly basis. This will ensure you and your customers are getting a clean and quality soda every time.
How often should soda nozzles be cleaned?
daily
Nozzles. When cleaning your fountain machine nozzles, make sure no chemicals are used. To maintain a tidy soda fountain machine, these should also be cleaned daily. Remove and dismantle the nozzles and soak them in hot water.
How do you clean a soda dispenser?
Turn the key switch to the off position. Remove the nozzles and diffusers for all valves by turning them counter clockwise and pulling down. Separate each nozzle from its diffuser and rinse all parts with warm water. Soak the nozzles and diffusers in sanitizing solution for 60-90 seconds.
Why is my soda gun not working?
If drinks are flat (no carbonation), check: If the carbonator is plugged in and the circuit breaker is working correctly. To see if the temperature is too warm. See “product too warm”. Replace tank if pressure is less than 400PSI.
How do you clear soda lines?
Empty, rinse, and fill the bucket with hot water, not above 140 degrees. Take plastic from the connector and place in the hot water. Activate the valve at the soda machine. Flush the line until the bucket is empty and repeat two or three times.