How do you delete a config on a Cisco switch?

How do you delete a config on a Cisco switch?

How do you delete a config on a Cisco switch?

Clear the configuration of your switch

  1. Log on. to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
  2. Enter clear config all to reset the. entire system. You don’t need to reload the switch because processing the. command wipes the switch.

How do I wipe a Cisco 2960x?

Reset a Cisco 2960 Switch To Factory Default Settings

  1. Connect up your console cable and power on the switch, whilst holding down the “mode” button:
  2. Initialize the flash file system with the command: flash_init.

How do I delete a VLAN on a Cisco switch?

Procedure

  1. To view all VLANs, type: show vlan.
  2. To enter configuration mode, type: configure terminal.
  3. To enter VLAN configuration mode, type: vlan vlan_id.
  4. To delete the specified VLAN, type: no vlan vlan_id.

How do I reset my cisco router to factory default?

Reset Router to Default Configuration

  1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
  2. Find the Reset button on the router.
  3. Press and hold the Reset button while you power on the router.
  4. Release the Reset button after 10 seconds.

How do I factory reset my cisco router?

How do you delete a VLAN?

Remove the VLAN by performing one of the following steps:

  1. To delete the VLAN temporarily, use the -t option as follows: # dladm delete-vlan -t vlan.
  2. To make the deletion persist, perform the following: Remove the VLAN. # dladm delete-vlan vlan. Remove the /etc/hostname. vlan-interface file.

How to reset a Cisco 2960 switch to factory default settings?

Reset a Cisco 2960 Switch To Factory Default Settings. 1 Step 1. Connect up your console cable and power on the switch, whilst holding down the “mode” button: This interrupts the boot process before the 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.

Can network management delete file and directory in Cisco 2960x?

Members & Recognition Cisco Community Technology and Support Networking Network Management cannot delete file and directory in Cisco 2960x 8713 Views 5 Helpful 9 Replies jnd23 Beginner Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Email to a Friend Report Inappropriate Content ‎07-06-201905:23 AM ‎07-06-201905:23 AM

What is a catalyst 2960 switch?

This appendix describes how to manipulate the Catalyst 2960 and 2960 switch flash file system, how to copy configuration files, and how to archive (upload and download) software images to a switch. Unless otherwise noted, the term switch refers to a standalone switch and to a switch stack.