How do you read a pool pump gauge?
A pool filter pressure gauge is the little dial usually located on top of the filter that reads the amount of pressure building up inside your filter. A typical pressure gauge is round, with an indicator needle and a range from 0 PSI (pounds per square inch) to a maximum reading of 60 PSI.
What should the pressure gauge read on my pool filter?
Generally speaking, a pressure reading between 10 – 25 psi can be considered normal. Once you have installed a new filter, turn everything on and take a baseline reading. Each time that you change your pool filter take a new baseline reading.
How do 3 way pool valves work?
A simple pool may have one 3-way valve installed in front of the pump, to control the flow from the skimmer and main drain. In most cases, the valve is turned to halfway close off the main drain, while the skimmer pipe is fully open. This results in 25% flow from the drain, and 75% flow from the skimmer.
What should Hayward pool filter pressure be?
The pool filter pressure should be steady, operating in a range of +/- 10 psi. When it’s outside this range, very low or very high, then you know that something’s wrong. Some gauges allow you to set the clean and dirty range, or you can write it on the filter tank with a marker.
What PSI should my Hayward pool filter?
If anything could be considered “normal”, it would be about 10 psi. Most filter systems are designed to operate in the 5-15 or 10-20 psi range. The way to find out your particular correct pool filter pressure is to clean or backwash the filter thoroughly and empty the pump and skimmer baskets.
How do I know if my pool pressure gauge is bad?
With the pool pump off, check your gauge—it should read zero. If it doesn’t, or if it reads zero when the pump is on, your gauge is probably ready to go. Examine the gauge dial for warping, which could indicate that you’ve got a broken gauge. You can also give it a flick, and see if the pressure momentarily pops up.