How much horsepower does a K24A1 have?
K24A1 – 160 hp (119 kW) at 6,000 rpm, 162 lb-ft (220 Nm) at 3,600 rpm. This engine was offered for Honda CR-V.
What car comes with a K24A1 engine?
Honda CR-V’s
K24A1. The K24A1 was the first engine that Honda released within the K24 range, which featured in the 2002-09 Honda CR-V’s, and came with 160 hp and 162 lb/ft torque. The A1 was where it all began, and it was a very similar engine to the B-series engine, with impressive low-end torque production.
How much boost can a K24 handle?
How much boost can a stock K24 take? The max flow on a K24 is rated around 37lbs/minute. You can expect about 370 hp at the crank (give or take) when the K24 is pushed to the limit. Of course you can try to push past this limit, but you will hit the point where you run into diminishing returns.
How much boost can stock K24 take?
How high can a k20 Rev?
power to 8800, max rev 9200.
Is K24 good for Turbo?
Since the K24 can handle forced induction well, it’ll come as no surprise that many owners opt to go down the turbocharged route with their build. If you intend to go beyond 400 hp, then a turbo kit will likely provide the best option for the money.
What is the horsepower of a K24A1 engine?
1. K24A1 is the first version of the engine described above. The power is 160 HP @ 6,000 rpm and the torque is 220 Nm @ 3,600 rpm, with the rev limit at 6,500 rpm. It was only installed in 2002-2006 Honda CR-V.
Can you add a turbo to a K24?
K24 Turbo upgrades The more air to get into an engine, the more fuel it can burn and uprating the induction with a turbocharger upgrade makes massive power gains. NASP engines need quite a lot of work when you add a turbo, so we have a separate guide to help you take into account the pros and cons of going this route on your K24
Are all K24 engine parts interchangeable?
USE THIS GUIDE FOR THE K24A SERIES ENGINES ONLY. THE Z SERIES ENGINES ARE NOT SUPPORTED. A few parts are ARE interchangeable: Crank pulley (Some K24 blocks use a pulley of a different diameter, you should measure to be sure you are using the correct one.)
What is the power of a K24A8?
The power is 160 HP @ 5,500 rpm, and the torque is 218 Nm @ 4,500 rpm, and the rev limiter is 6,800 rpm. 5. K24A8 is an analogue to K24A4, but for a different environmental standard.