How do I program STM32 with St-Link utility?
Introduction
- Download the STM32 ST-LINK Utility from ST web site and install it in your development machine.
- Download a ZIP file with the firmware for the board from our web site here by clicking on the appropriate badge.
- Connect the target board to your PC using an USB cable.
How do I install ST-Link utility?
Installing the STM32 ST-LINK utility Extract the contents of the . zip file into a temporary directory. 3. Double-click the extracted executable, setup.exe, to initiate the installation, and follow the on-screen prompts to install the STM32 ST-LINK utility in the development environment.
What is STM32 St-Link utility?
Description. STM32 ST-LINK Utility (STSW-LINK004) is a full-featured software interface for programming STM32 microcontrollers. It provides an easy-to-use and efficient environment for reading, writing and verifying a memory device.
How do I download St-Link driver?
Installation instructions
- Download the latest ST-LINK/V2 driver.
- Extract the archive and run either dpinst_amd64.exe or dpinst_x86.exe depending on whether you are on a 64-bit machine or 32-bit machine. Follow the displayed instructions.
- You should now have successfully installed the ST-LINK/V2 driver.
How do I flash a program to STM32?
Programming the STM32 Flash Start the STM32 ST-LINK Utility program. There will be a link to the utility on the desktop. In Windows 7 it can also be found under Start → All Programs → STMicroelectronics → STM32 ST-LINK Utility → STM32 ST-LINK Utility.
How do I start learning STM32?
2 STM32 step by step↑
- Step 1: Tools installation and first test. Install the main tools to program STM32 and run a first example:
- Step 2: Blinking LED with STM32CubeMX and HAL.
- Step 3: UART and new board introduction.
- Step 4: Sensors usage with B-L475E-IOT01A.
- Step 5: Build an IOT system.
How do I connect my STM32 to my computer?
Just use the micro-USB port on the STM32 board to connect it to the computer as shown below. Make sure the jumper 0 pin is positioned back at 0 (Operating mode). Hereafter we need not toggle the jumper anymore to upload and run the programs. You computer should be able to discover the Board now.