How do I use the Nanoscope IIIa multimode?
Multimode: Nanoscope IIIa Starting Switch on the computer. Log in on the computer (Gaspar login) Double click on CEA and login using your AFM password. (See P. Charpilloz) Start the program “Nanoscope V530R” (the AFM will start automatically), • Switch on the camera’s lamp.
What is in the Nanoscope™ system manual?
The NanoScope™ System Manual identifies critical, important, and useful information using these symbols and conventions. 1.1 Important Safety Conventions Warnings and safety conventions follow IEC 60601-1. Users of this device are encouraged to contact their Arthrex representative if they require a more comprehensive surgical technique.
What are the power requirements for the Nanoscope system?
Mains power quality should be that of a doctor’s office, typical commercial or hospital environment. If the NanoScope System requires continued operation during power mains interruptions, it is recommended that the NanoScope System be powered from an uninterruptible power supply. Power frequency (50/60 Hz) magnetic field
What are the part numbers for the Nanoscope software?
NanoScope Software 6.13 User Guide Part Numbers 004-132-000 (Standard) 004-132-100 (Cleanroom) Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WAR- RANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
What is Veeco nanoscope III?
A Veeco (formerly Digital Instruments) Nanoscope III was installed in September 2005. This instrument is capable of tapping and contact-mode atomic force microscopy (AFM), scanning tunneling microscopy (STM), magnetic force microscopy, and force-modulation microscopy. In addition, it has a multimode heater and cooler for in-situ studies.
What are the tools available in nanoscope?
Standard NanoScope ® tools exist for direct MATLAB import of data and ASCII export.You can monitor internal signals and customize signal inputs with Virtual SAM, or expand your capabilities with optional SAM lll. Control of AFM functions are available through optional nanolithography and NanoScope COM interface.
How to tune the AFM of the Nanoscope v530r?
Start the program “Nanoscope V530R” (the AFM will start automatically), • Switch on the camera’s lamp. • In the program, click on the microscope symbol to connect the computer to the AFM. Tunning of the laser Mount the tip on the support holder (see Figure 2). You can check with the mononocular if the tip is in a good shape.