How do you adjust an Apollo PEX Clamp Tool?

How do you adjust an Apollo PEX Clamp Tool?

How do you adjust an Apollo PEX Clamp Tool?

How To Calibrate Apollo PEX Crimp Tool

  1. For adjusting the crimp force of your device, open up the handle of your crimp tool, locate one of the nuts that has numbers around it and loosen up this nut.
  2. Now, press on to the screw and rotate it in order to decrease or increase the number as you desire.

How do you cinch clamp PEX?

PEX tubing. PEX cutter tool. Brass or Poly PEX crimp fitting(s) PEX cinch clamps….Safety first – always wear appropriate eye protection gear.

  1. Position the cutter perpendicular to the PEX pipe and make a smooth, clean cut.
  2. Slide the PEX cinch clamp over the pipe.
  3. Fully insert the PEX crimp fitting into the pipe.

How do you use the one hand PEX pinch clamp tool?

Place pinch clamp nub between tool jaws and ratchet the clamp (approximately seven times) until the LEDlight comes on. This will assure that the pinch clamp is fully engaged. 4. To release the Pinch Tool, rotate the release lever on the side.

How do you unlock crimping tool?

Open the tool by squeezing the handles together, at the end of the closing stroke, the ratchet mechanism will release the handles, and the hand tool will spring open.

Is Apollo PEX-A or B?

Apollo offers PEX-A (Expansion PEX) and PEX-B tubing. PEX-A tubing (Expansion PEX) is produced using the Peroxide or Engel method. Molecules of HDPE polymer are cross-linked during the extrusion process. PEX-B tubing is produced using the Silane or moisture-cured method.

Are sharkbite and Apollo interchangeable?

Apollo manufactures both Pex-A and Pex-B. If your supplier is selling Sharkbite fittings, all sharkbite fittings will work on all three types of Pex.

How do you adjust a PEX tool?

Pull the handles of the tool together to crimp the sleeve.

  1. Slide the properly-sized crimp gauge over the crimped sleeve.
  2. Close the jaws of the crimp tool until you feel resistance.
  3. Turn the locking screw clockwise with the hex wrench to lock the crimp tool adjustment.
  4. Crimp another metal sleeve.

What are the arrows on PEX clamps?

A: These plastic tabs create the perfect offset between the end of pex tube and clamp, it’s the reason they are there. The arrow is meant to point away from end of tubing because the other side has the longer gap setting tab.