What is the default IP of DAP-1360?
| IP Address | 192.168.0.50 Load Admin |
|---|---|
| Username | admin |
| Password | |
| SSID | |
| Users Manual | Manual 2 |
How do I configure the Access Point DAP-1360?
– Connect the repeater directly to the Router via a network cable. – Make a reset of the access point (DAP-1360) by pressing button (reset) to the right (next to one of the anten-nas) until the LED begins flashing. – Wait for about one minute for the computer to start again then begin with the configuration.
How do I access my Dlink access point settings?
How to change a D-Link router to AP mode
- Connect a computer to the D-link router and launch a web browser.
- Visit the following router configuration page: http://192.168.0.1.
- You are prompted to enter a username and password.
- Click Setup > Local Network.
- Set the DHCP Mode to Off.
- Click Apply Changes.
How do I reset my DAP 1360?
Reset the Dlink DAP-1360 router The reset button is located on the back of the router. Use a sharp tool eg. paperclip or a pen to press the button. Press and hold the button for 20 seconds, the router will restart and reset to the factory settings.
How do I setup my Dlink DAP 1325?
Easy to Set Up, Easy to Use Setting up the N300 Wi-Fi Range Extender is simple. Just push the WPS push-button on the DAP-1325 and on the router or AP you want to extend, and the DAP-1325 will automatically configure itself for you.
How do I reset my DAP-1360?
How do I reset my DRA 1360?
Use an unfolded paperclip to press and hold the reset button on the bottom of DRA-1360 for 10 seconds to restore the factory default settings. You may locate the Wi-Fi name (SSID) and password for your DRA-1360. This information is printed on the specification sticker on the back of the device.
How do I reset my D-Link WiFi extender?
Using a paperclip, press and hold the reset button for 10 seconds (or until the LED on the front turns red), and then let go. The extender will then reboot and be at factory default settings.
Is D Link DAP-1360 a router?
The DAP-1360 offers seven modes of operation, namely Access Point, Wireless Client, Bridge, Bridge with AP, Repeater, WISP Client Router, and WISP Repeater (Range Extender) Mode. These modes allow you to flexibly configure the device for use with different wireless applications.
What the modes of preparation that the DAP-1360 can offers?
– The DAP-1360 offers seven modes of operation, namely Access Point, Wireless Client, Bridge, Bri. These modes allow you to flexibly configure the device for use with different wireless applications.
How to reset the dap-1360 to default settings?
– Make a reset of the access point (DAP-1360) by pressing button (reset) to the right (next to one of the anten-nas) until the LED begins flashing. – Wait for about one minute for the computer to start again then begin with the configuration.
How do I connect my D-Link dap-1360 extender to my router?
Disconnect the ethernet cable (RJ45) from your router and connect it to your D-Link DAP-1360 Extender for this setup. Obtain you Default Gateway (for more information, see How to obtain your Default Gateway) Open your Internet Browser, such as Internet Explorer, Google Chrome, etc…
How do I configure the access point dap-1360 as a repeater?
How do I configure the Access Point DAP-1360 as a repeater? – Connect the repeater directly to the Router via a network cable. – Make a reset of the access point (DAP-1360) by pressing button (reset) to the right (next to one of the anten-nas) until the LED begins flashing.