What is the pet Turbo eraser used for?
The Pet TurboEraser Tool provides portability for help with different areas of your home. Attach the tool to the handle to pick up pet hair on your stairs. For couches and pillows, this tool also has you covered.
How does Bissell turbo brush work?
The TurboBrush® Tool has a rotating brush that easily connects to most vacuum hoses and is recommended for cleaning stairs, upholstery, rugs and other difficult to reach areas in your home while vacuuming. The TurboBrush® Tool stores on board most BISSELL vacuums for easy and convenient above floor cleaning.
How do you open a turbo eraser pet?
More videos on YouTube
- Press the Dirt Tank Release Button and grab the handle to pull the tank away from the vacuum.
- Hold the dirt tank over a trash bin and press the Release Button.
- While the tank is open, remove the separator by gripping the inner tube and twisting counter-clockwise.
How do you use a Bissell Pet eraser?
Machine Use
- Fill Tank to Fill Line with BISSELL formula.
- Press Power Button to turn ON.
- Use Spray Trigger to spray formula.
- Scrub mess with Brush back and forth.
- Use the Suction Nozzle to suction formula from cleaning surface.
- Enjoy 15 minutes of run time to conveniently clean anywhere.
Why is my Bissell Pet Hair won’t suction?
Check to make sure the Vacuum Suction Knob is turned towards “Floor Suction.” Or there could be large debris clogging the brush roll rotation. Your dirt container may not be seated properly or may be full. Press the Tank Release button and remove.
How do you turn on the BISSELL turbo brush?
More videos on YouTube
- To turn the vacuum on, plug it into a grounded outlet and press the Power Switch to the ON position.
- Next, turn the brush roll switch ON to use the Power Brush for carpet cleaning.
- For bare floors, you’ll want to make sure the Brush Roll is OFF.
How do you clean a BISSELL Powerforce turbo vacuum?
Press the filter cover release button to access the post motor filter. Clean all the filters with mild detergent, rinse, and squeeze all excess water. Allow filters to dry completely before reinserting. To clean your separator, the dirt container must be removed.