Which extractor fan is the quietest?
The Vent Axia Silent Fan scores particularly well on noise, quietly doing its work at 21dB(A). It is in fact the most silent extractor fan on the market. However, the Vent Axia Silent fan achieves this lower noise at the cost of all important extraction rate.
Is Vent-Axia an extractor fan?
Vent-Axia Bathroom Extractor Fans are available in a variety of switch types to suit any application and are designed to eliminate condensation and mould build up within your bathroom.
How does a Vent-Axia fan work?
The whole house system works by replacing the warm stale moist air from the house, with fresh air from outside. The fresh air passes through a highly efficient heat exchanger and is prewarmed by the heat which is recovered from the extracted air. The heat exchanger recovers up to 70% heat from the outgoing stale air.
How can I make my extractor fan quieter?
How To Make a Kitchen Extractor Fan Quieter
- Clean your kitchen extractor fan.
- Lubricate the motor.
- Straighten the ductwork.
- Tighten the mounting equipment.
- Insulate your kitchen extractor fan.
- Replace an old fan.
Can a bathroom fan be silent?
Their QTX Very Quiet bathroom exhaust fan is dead-quiet at 0.3 sones, one of the quietest bathroom fans you can buy. But you do pay the cost in terms of low volume. If you don’t need a high capacity fan and noise is important to you, the Broan Very Quiet might be right for your bathroom.
Where are Vent-Axia made?
Britain
Not only it is a design classic, it is a British design classic. Made in Britain, the popular T-Series has been manufactured at Vent-Axia’s Crawley facilities in West Sussex since its launch.
Can I turn off my Vent Axia?
To switch the unit off: at the unit’s local isolator, turn the power off.
How do you clean an Axia vent filter?
No parts specified.
- Step 1 How to clean the Vent-Axia MVHR Cell.
- Remove the 6 screws from the heat recovery panel.
- Remove the internal filter on the left hand side using the pull tab.
- Gently take the cell by the pull tab.
- Clean the cell on each side with a hoover to remove any dust.